Description
Application areas:
Suitable for all metals for machining operations where emulsifiable oil are normally used. The recommended concentration is between 5 to 10 % depending on the severity of machining. Sometimes used successfully for even grinding operations.
Detail Description
This is general-purpose emulsifiable oil and forms milky white emulsion.
HP Koolkut 40 is a dependable soluble cutting fluid that HP Lubricants has specially formulated for general machining operations where emulsifiable cutting oils are typically used. HP Koolkut 40 is a product of HP Lubricants Lube Tradeways, and it can be used for machining all kinds of ferrous and non, ferrous metals in workshops and different industrial units.
HP Koolkut 40 will create a stable, milky white emulsion after mixing with water that will provide not only effective cooling but also consistent lubrication at the cutting zone. As a result, heating is lessened, the tool has a longer life, and the surface finish gets better during machining. The fluid concentration of 5% to 10% is advised depending on the severity of the machining and the load on the tool.
HP Koolkut 40 works excellently in turning, drilling, milling, tapping, and general machining operations. Its effective cooling property makes it also suitable for some light grinding applications where temperature control is of utmost importance. The composition provides good emulsion stability and resistance to bacterial growth, allowing for cleaner sumps and longer fluid life.
With proven performance and cost, effectiveness, HP Koolkut 40 is the perfect solution for daily metalworking needs.
Performance benefits:
- Good surface finish
- Built in protection against bacterial growth Excellent emulsion stability
- Good heat removal properties
Physico-chemical properties
| PROPERTIES | TYPICAL VALUES |
|---|---|
| KOOLKUT 40 | |
| Colour After Emulsification | Milky White |
| Kinematic Viscosity @ 40 °C, Min, cSt | 20 |
| Flash Point, COC °C, Min | 150 |
| Copper Corrosion @100 °C, Min | 1 |
| Cast Iron Corrosion Test, 20:1 Emulsion with 400 PPM Hard Water Max | 0/1-1 |
| Emulsion Test: 400 PPM Hard Water 5:1 and 20:1 Ratio | PASS |
